Pioneer AVIC-X1 User Manual
Page 91

89
Chapter 8
Customising the Audio Source Setting
AV
Switching Auto PI Seek
The unit can automatically search for a different
station with the same programming, even during
preset recall.
1
Touch “AUTO PI” in the INITIAL menu.
Touching “AUTO PI” switches between “ON”
and “OFF”.
Switching the auxiliary setting
It is possible to use auxiliary equipment with nav-
igation unit. Activate the auxiliary setting when
using auxiliary equipment connected to naviga-
tion unit.
1
Touch “AUX” in the INITIAL menu.
Touching “AUX” switches between “ON” and
“OFF”.
Selecting the illumination col-
our
This unit is equipped with two illumination col-
ours, green and red. You can select the desired
illumination colour.
1
Touch “ILLUMI” in the INITIAL menu.
Touching “ILLUMI” switches between
“GREEN” (green) and “RED” (red).
Setting the rear output and sub-
woofer controller
This unit’s rear output (rear speaker leads output
and RCA rear output) can be used for full-range
speaker (REAR SP FULL) or subwoofer (REAR
SP SUB. W) connection. If you switch the rear
output setting to the REAR SP SUB. W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, navigation unit is set for rear full-range
speaker connection (REAR SP FULL). When
rear output is connected to full range speakers
(when REAR SP FULL is selected), you can con-
nect the RCA subwoofer output to a subwoofer.
In this case, you can select whether to use the
subwoofer controller’s (low pass filter, phase)
built-in PREOUT SUB. W or the auxiliary
PREOUT FULL.
1
Touch “REAR SP” in the INITIAL menu.
2
Touch “REAR SP” to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select FULL.
When a subwoofer is connected to the rear
output, select SUB. W.
❒ When the rear output setting is SUB. W,
you cannot change the subwoofer control-
ler.
3
Touch “PREOUT” to switch the sub-
woofer output or non fading output.
❒ Even if you change this setting, there is no
output unless you turn “NON FADING” or
“SUB WOOFER” in the AUDIO menu
“ON”.
➲ Using non fading output ➞ Page 85
➲ Using subwoofer output ➞ Page 85
❒ If you change the subwoofer controller
(REAR SP), the subwoofer output (SUB
WOOFER) and non fading output (NON
FADING) in the AUDIO menu return to
the factory settings.
❒ Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Switching the sound muting/
attenuation
Sound from this system is muted, attenuated or
mixed automatically in the following cases:
• When a call is made or received using a cellu-
lar telephone connected to navigation unit.
• When the voice guidance is output.
1
Touch “TEL/GUIDE” in the INITIAL menu.
Each touch of the “TEL/GUIDE” changes the
settings as follows:
• MUTE — Muting
• ATT — Attenuation
• NORMAL — Volume does not change
❒ The sound is turned off, no audio adjust-
ment is possible.
❒ When a phone connection is made,
MUTE or ATT is indicated.
❒ Operation returns to normal when the
phone connection or the voice guidance is
ended.
Initial Settings
CRB1903B_ENGLISH.book Page 89 Friday, April 30, 2004 9:27 PM