Pioneer PDR-F10 - Manual (Page 14)

4 Getting Started
14
En
Pressing
4 once takes you to the
beginning of the current track. Further presses
skip to the start of previous tracks.
You can use the track skip buttons while the
disc is paused, too. The track number changes
while the disc remains paused.
6 To stop playback, press
7.
If the disc was paused, then pause is canceled.
The display shows the number of tracks on
the disc and the total playing time when the
disc is stopped.
Tip
In step
2 above, pressing the CD - R button
closed the disc compartment and set the disc
playing. In fact, pressing this button is always
the quickest way to play a disc. If there's
already a disc in the player, then pressing the
CD - R button — even when the system is in
standby mode — will switch the system on
and start the disc playing.
Caution!
Be careful not to trap your fingers in the disc
compartment as it closes automatically.
After the disc compartment closes, the
recorder first determines the kind of disc
loaded. Next, it reads the TOC, then starts
playing the disc.
You can also use the top panel controls:
6 closes the disc compartment and starts
the disc playing.
OPEN / CLOSE closes the disc compartment
without starting playback (the disc compart-
ment closes automatically after 60 seconds).
3 To pause playback, press the
CD-R button.
To resume playback, press again.
You can also use the top panel controls:
Press
6 once to pause playback; press
again to resume.
4 To fast-reverse or fast-forward,
press and hold
1 or ¡.
Release the button to resume normal
playback.
5 To skip back or forward to
another track, press (but don't
hold)
4 or ¢.
Pressing
¢ once skips to the start of the
next track on the disc. Further presses take
you to subsequent tracks.