Interface mode, Interface mode -19, R further information – Brother HL-2060 User Manual

Page 94: See “mode switch” in chapter, For further information, See “mode switch” in chapter 4, Since the, See 4-19.)

CHAPTER 4 CONTROL PANEL

4–19

6. Press the ▲ or ▼ switch until the exit menu appears on the display.

exit MODE

7. Press the SET switch.

Then the printer automatically returns to the off-line ready state.

INTERFACE MODE

The automatic interface selection has been factory set. If you want to
select a specific interface manually, use the interface mode to set it.

Display Message

Interface Mode

I/F=PARALLEL

Parallel interface

I/F=RS-232C

Serial interface

I/F=USB

Universal Serial Bus interface

I/F=OPTION

Optional interface for MIO card

I/F=AUTO

Auto interface selection

Select the setting menu and enter the sub-setting menu to change the
setting as follows:

■ Automatic Interface Selection

1. When you use the automatic interface selection function, select the

function on the display as follows:

I/F=AUTO

2. When you select this function with the SET switch, the display shows

the next sub-setting menu as follows:

TIME OUT