Brother HL-2060 - Manual (Page 88)

CHAPTER 4 CONTROL PANEL
4–13
MODE Switch Settings in BR-Script 2 Mode
The following table shows all the selections you can make with the
MODE switch in the BR-Script 2 mode.
✒ Note
The mode menus and settings that can appear vary according to the
current emulation mode, printer status, and any options that may be
installed in the printer.
Mode Menu Setting Menu Sub-Setting Menu Setting
INTERFACE MODE
Same as HP LaserJet Mode
(See 4-19.)
FORMAT MODE X OFFSET=0 -500 (left) to +500 (right) dots
(See 4-22.) Y OFFSET=0 -500 (up) to +500 (down) dots
exit Exit to PAGE FORMAT MODE
RESOLUTION MODE RESOLUTION RESOLUTION=600 300, 600 or 1200 dpi
(See 4-31.) APT SETTING APT=OFF ON or OFF
HRC SETTING HRC=MEDIUM OFF, LIGHT, MEDIUM, or DARK
exit Exit to RESOLUTION MODE
CARD OPERATION When the commercial flash memory card or the HDD card has not been formatted:
(See 4-37.) CARD 1
CARD 2
exit
FORMAT CARD Format the flash memory card or
the HDD card.
exit Exit to CARD OPERATION
CARD 1 (2)
CARD OPERATION When the commercial flash memory card or the HDD card has been formatted:
(See 4-37.) CARD 1 EXECUTE DATA Execute the data on the card.
CARD 2 DATA ID=##### Execute the selected data.
CARD LIST Print the contents of the card.
SAVE SAVE DATA Send data to be saved.
SET KEY--> END End saving the data.
DATA ID=##### Set data ID for saved data.
exit Exit to CARD OPERATION
DELETE MACRO ID=##### Delete the selected macro.
DATA ID=#### Delete the selected data.
FONT ID=##### Delete the selected font.
FORMAT CARD Format the card.
SET –> DELETE ALL Execute formatting the card.
exit Exit to FORMAT CARD
OPERATION
exit Exit to CARD 1 (2) OPERATION