Olympus E-400 - Manual (Page 58)

58
Remote control shooting
Shooting functions
k
V
a
rious shooting function
s
3
TIPS
The remote control lamp does not blink after the shutter button on the
remote control is pressed:
J The transmitted signal may not be effective if the remote control receiver is
exposed to powerful lighting. Move the remote control closer to the camera and
press the shutter button on the remote control again.
J The transmitted signal may not be effective if the remote control is too far from
the camera. Move the remote control closer to the camera and press the shutter
button on the remote control again.
J There is signal interference. Change the channel as described in the remote
control’s manual.
To cancel the remote control shooting mode:
J The remote control shooting mode will not be canceled after shooting. Press the
Y/j button to set to o (single-frame shooting) etc.
To use the shutter button on the camera in the remote control shooting
mode:
J The shutter button on the camera still works even in the remote control shooting
mode.
Bulb shooting on the remote control
Set the mode dial to M, then set the shutter speed to [BULB].
x Notes
• The shutter will not be released if the subject is not in focus.
• Under bright light conditions, the remote control lamp may be difficult to see,
making it hard to determine whether or not the picture has been taken.
• Zoom is not available on the remote control.
Press the W button on the remote
control to open the shutter.
If 8 minutes elapse after pressing
the W button, the shutter closes
automatically.
Press the T button to
close the shutter.