Agilent Technologies 6631B - Manual (Page 83)

83
B
Compatibility Language
Introduction
The Agilent power supplies covered by this manual are programmatically compatible with the HP/Agilent
6632A, 6633A, and 6634A dc power supplies. This means that by using COMPatibility language mode you
can program these newer dc sources over the GPIB using COMPatibility commands.
To switch from SCPI commands to COMPatibility commands (and vice versa), use the SYST:LANG
command, as documented in chapter 4. The language setting is saved in non-volatile memory.
Table B-2 summarizes the COMPatibility commands that program the supplies. You may need to refer to
the HP/Agilent Series 6632, 6633A, and 6634A Operating Guide (p/n 5957-6360) for complete information
on the COMPatibility commands.
The rest of this appendix discusses the COMPatibility language status system, and the COMPatibility
language error codes.
Note: For complete information on the Compatibility programming language, order the
HP/Agilent 6632A/6633A/6634A Operating manual, p/n 5957-6360.
Table B-1. COMPatibility Power-on Settings
Command Setting Command Setting
DC 1 (ON) POL 1 (normal)
DLY 8 ms (fast)
80 ms (normal)
PON last stored value
DSP 1 (ON) RELAY 1 (close)
ISET 0.04 A (6631B)
0.02 A (6632B)
0.008 A (6633B)
0.004 A (6634B)
RLYPON 1 (close)
OCP OFF SRQ 0
OUT 1 (ON) UNMASK 0
OVSET MAX VSET 0 V