Agilent Technologies 6631B - Manual (Page 73)

Language Dictionary - 4
73
Trigger Commands
Trigger commands consist of trigger and initiate commands.
Trigger commands control the remote triggering of the dc source . Trigger commands (and Initate
commands) are referenced either by name or by number. The correspondence between names and
numbers is:
Sequence Number
Sequence Name Description
1 (the default) TRANsient Output transient trigger sequence
2 ACQuire Measurement acquire trigger sequence
Initiate commands initialize the trigger system.
ABORt
This command cancels any trigger actions presently in process. Pending trigger levels are reset to their
corresponding immediate values. ABORt also resets the WTG bit in the Operation Condition Status
register (see chapter 3 under Programming the Status Registers). If INITiate:CONTinuous ON has been
programmed, the trigger subsystem initiates itself immediately after ABORt, thereby setting WTG. ABORt
is executed at power turn on and upon execution of *RCL or RST.
Command Syntax ABORt
Parameters None
Examples ABOR
Related Commands INIT *RST *TRG TRIG
INITiate:SEQuence
INITiate:NAME
INIT:SEQ2 or INIT:NAME ACQ applies to Agilent 66312A, 66332A Only
INITiate commands control the initiation of both output and measurement triggers. When a trigger is
enabled, an event on a selected trigger source causes the specified triggering action to occur. If the trigger
subsystem is not enabled, all trigger commands are ignored.
Command Syntax INITiate[:IMMediate]:SEQuence[ 1 | 2 ]
INITiate[:IMMediate]:NAME
Parameters For INIT:NAME TRANsient | ACQuire
Examples INIT:SEQ2 INIT:NAME TRAN
Related Commands ABOR INIT:CONT TRIG TRIG:SEQ:DEF *TRG
INITiate:CONTinuous:SEQuence1
INITiate:CONTinuous:NAME
These commands control the output transient trigger system.
1 or ON
continuously initiates the output trigger system..
0 or OFF turns off continuous triggering. In this state, the output
trigger system must be initiated for each trigger using INITiate:SEQuence.
Command Syntax INITiate:CONTinuous:SEQuence1
INITiate:CONTinuous:NAME TRANsient,
Parameters 0 | 1 | OFF | ON
Examples INIT:CONT:SEQ ON INIT:CONT:NAME TRAN, 1
Related Commands ABOR INIT TRIG TRIG:SEQ:DEF *TRG