Agilent Technologies 6631B - Manual (Page 56)

4 - Language Dictionary
56
OUTPut:PON:STATe
This command selects the power-on state of the dc source. This information is saved in non-volatile
memory. The following states can be selected:
RST Sets the power-on state to *RST. Refer to the *RST command as described in this chapter
for more information.
RCL0 Sets the power-on state to *RCL 0. Refer to the *RCL command as described in this
chapter for more information.
Command Syntax OUTPut:PON:STATe
Parameters RST | RCL0
Examples OUTP:PON:STAT RST
Query Syntax OUTPut:PON:STATe?
Returned Parameters
Related Commands *RST *RCL
OUTPut:PROTection:CLEar
This command clears the latch that disables the output when an OverVoltage, OverCurrent,
OverTemperature, Remote Inhibit, or Fuse Status condition is detected. All conditions that generate the
fault must be removed before the latch can be cleared. The output is then restored to the state it was in
before the fault condition occurred.
Command Syntax OUTPut:PROTection:CLEar
Parameters None
Examples OUTP:PROT:CLE
Related Commands OUTP:PROT:DEL *RCL *SAV
OUTPut:PROTection:DELay
This command sets the time between the programming of an output change that produces a constant
current condition (CC) and the recording of that condition by the Operation Status Condition register. The
delay prevents the momentary changes in status that can occur during reprogramming from being
registered as events by the status subsystem. Since the constant current condition is used to trigger
overcurrent protection (OCP), this command also delays OCP. Overvoltage protection is not affected by
this comand.
Command Syntax OUTPut:PROTection:DELay
Parameters 0 to 2,147,483.647
Unit seconds
*RST Value 0.08 (Normal)
Examples OUTPUT:PROTECTION:DELAY 75E-1
Query Syntax OUTPut:PROTection:DELay?
Returned Parameters
Related Commands OUTP:PROT:CLE *RCL *SAV