Agilent Technologies 6631B - Manual (Page 42)

4 - Language Dictionary
42
Table 4-1. Subsystem Commands Syntax (continued)
STATus
:PRESet Presets all enable and transition registers to power-on
:OPERation
[:EVENt]? Returns the value of the event register
:CONDition? Returns the value of the condition register
:ENABle Enables specific bits in the Event register
:NTRansition Sets the Negative transition filter
:PTRansition Sets the Positive transition filter
:QUEStionable
[:EVENt]? Returns the value of the event register
:CONDition? Returns the value of the condition register
:ENABle Enables specific bits in the Event register
:NTRansition Sets the Negative transition filter
:PTRansition Sets the Positive transition filter
SYSTem
:ERRor? Returns the error number and error string
:LANGuage Sets the programming language (SCPI | COMP)
:VERSion? Returns the SCPI version number
:LOCal Go to local mode (for RS-232 operation)
:REMote Go to remote mode (for RS-232 operation)
:RWLock Go to remote with local lockout (for RS-232 operation)
TRIGger
:SEQuence2 | :ACQuire
[:IMMediate] Triggers the measurement immediately
:COUNt
:CURRent Sets the number of sweeps per current measurement
:VOLTage Sets the number of sweeps per voltage measurement
:HYSTeresis
:CURRent Qualifies the trigger when measuring current
:VOLTage Qualifies the trigger when measuring voltage
:LEVel
:CURRent Sets the trigger level for measuring current
:VOLTage Sets the trigger level for measuring voltage
:SLOPe
:CURRent Sets the triggered current slope (POS | NEG | EITH)
:VOLTage Sets the triggered voltage slope (POS | NEG | EITH)
:SOURce Sets the trigger source (BUS | INT)
[:SEQuence1 | :TRANsient]
[:IMMediate] Triggers the output immediately
:SOURce Sets the trigger source (BUS)
:SEQuence1
:DEFine TRANsient Sets or queries the SEQ1 name
:SEQuence2
:DEFine ACQuire Sets or queries the SEQ2 name