Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-16179 - Manual (Page 26)

Using the lpr utilities Using the lpr Utilities for DOS and UNIX
2-8
Save
–C"(print|save)"
Save the specified job. Print is the default option and only
needs to be specified if the job is being submitted to a
save queue.
–C"(savedest=)"
Specify the save location of the job relative to the save
location set at the DocuSP controller. For example, if the
save location at the controller is /home/savefiles and the
save location for the job should be /home/savefiles/orilee,
then the command is:
lpr -P ps1 -C"(save,savedest=orilee)" test.ps
Sides printed
–C"()"
Specify simplex, duplex, or tumble duplex for the print job.
The default is "simplex" if you do not specify this option.
Tumble duplex printing causes a 180-degree rotation of
alternating pages. Both sides of the page are printed but
the position of the image is reversed (from top to bottom)
on every other page.
NOTE: The use of tumble duplex is restricted by certain
characteristics of the PostScript master. If you have
difficulty using this option, contact your Xerox
representative for assistance.
Slip sheets
–C "(slipsheet)"
Specify a slip sheet to be placed between the sets of your
document. The slip sheet stock is set at the DocuSP
controller.
Start message
-C "(startmsg)"
Type a message, up to a maximum of 100 characters. For
example, you might type a message that specifies some
unique job programming that must be provided by the
printer operator. Be sure to advise the printer operator
that the job contains a message.