Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-16179 - Manual (Page 23)

Using the lpr Utilities for DOS and UNIX Using the lpr utilities
2-5
Image shift – y
–C"(yshift=<#>)"
Specify the y (vertical for portrait page) image shift in
millimeters. The value of # must be a positive value
greater than zero. The point of origin is the lower left
corner of the portrait page.
–C"(yshift2=<#>)"
If your printing requirements include duplex or tumble
duplex, you can select an independent vertical image shift
for both side 1 and side 2.
Number of Copies
–#
Specify the number of copies to print of each specified
filename. If the number of copies is not specified, a default
of "1" is applied and will override any copy count defined
in the PDL.
Opacity
–C"(opacity=)"
Specify if the job will be printed on transparent stock. If
this option is not used, the default is opaque.
Pages to print
–C"(pagestoprint=<# #>)"
Specify the specific pages, from # to #, within the
document to print.
Paper stock
–C"(media=size:type:color:weight)"
Allows you to define the following options in order:
• Paper size = USLetter, USLegal, USLedger (17 x 11
inches), Tabloid, USStatement, a0 through a10, isob0
through isob10, jisb0 through jisb10, or custom where
a custom size is entered as width (x) and length (y) in
either inches or millimeters. See the example below.
• Paper type = same values as for the Paper Type
(prefinish) option. For ordered paper types, enter the
modulus number. The default modulus is 1.