Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-16179 - Manual (Page 22)

Using the lpr utilities Using the lpr Utilities for DOS and UNIX
2-4
Finishing options - stitch
-C”(stitch | staple=)”
Staple the document after it is printer. You can enter
“stitch” or “staple” to indicate that the document is to be
stapled. “Staple” is equivalent to stitch = singlePortrait.
The stitch option allows you to select the location of the
stitch or staple. The available options are: singlePortrait,
singleLandscape, dualLandscape, dualPortrait,
rightSinglePortrait, rightSingleLandcape, or
rightDualLandscape. The staple option default to a single
portrait stitch if no option is given. To use this option, the
selected printer must have a stitcher or stapler.
Finishing options – other finishing devices
–C"(finishing=)"
Specify an attached finishing device. The device name
must match the name defined by the System
Administrator on the DocuSP controller. See the Print
Service Operator for the list of defined device names.
Finishing options – no finishing
–C”(nofinishing)”
The no-finishing option would be used to override all
finishing selections other than those provided by the
overrides on the queue. Typically, this option would be
used when reprinting a job.
Image shift – x
–C"(xshift=<#>)"
Specify the x (horizontal for portrait page) image shift in
millimeters. The value of # must be a positive value
greater than zero. The point of origin is the lower left
corner of the portrait page.
–C"(xshift2=<#>)"
If your printing requirements include duplex or tumble
duplex, you can select an independent horizontal image
shift for both side 1 and side 2.