Xerox DocuColor 240-250 con Xerox FreeFlow DXP250-16179 - Manual (Page 14)

Installation Using the lpr Utilities for DOS and UNIX
1-4
Native lpr printing protocol for SunOS 4.1.3
This section describes the procedures for configuration of the
client workstation and the DocuSP controller to enable native lpr
printing.
Workstation requirements
The workstation must meet the following hardware and software
requirements:
Hardware requirements
• Sun workstation
Software requirements
• SunOS 4.1.3
Installation
NOTE: Refer to the on-line man pages for additional information
about the Unix commands used in the following procedure.
To configure the client workstation, perform the following steps:
1. Obtain the list of DocuSP controller queues that will be
accessed from this client workstation.
2. Log in as root at the client workstation.
NOTE: The following examples use the name proofqueue as the
name of the print queue and the name printsrv as the hostname
of the DocuSP controller. These should be replaced by the
hostname of the DocuSP controller and the name of a print
queue that exists in your installation.
3. If the system is not in an NIS environment, you must add an
entry for the DocuSP controller to the /etc/hosts file on the
SunOS 4.1.3 client workstation, similar to the following
example:
127.0.0.1 localhost
255.255.255.255 printsrv