Konica Minolta bizhub C31P - Manual (Page 237)

Status, Error, and Service Messages 223
TRANS. BELT
END OF LIFE The transfer belt unit
has reached the end
of its life. Replace the transfer belt
unit and reset the
counter in the
MAINTE-
NANCE MENU/SUP-
PLIES/REPLACE/
TRANS. BELT
menu.
TRANS.ROLLER
END OF LIFE The transfer roller has
reached the end of its
life. Replace the transfer
roller and reset the
counter in the
MAINTE-
NANCE MENU/SUP-
PLIES/REPLACE/
TRANS. ROLLER
menu.
UNABLE TO
COLLATE JOB The hard disk is full.
Print jobs over 10,000
pages cannot be col-
lated. Print one copy of the file
at a time.
UNABLE TO
STAPLE JOB A job set for stapling
contains pages that
exceed the number of
pages that can be sta-
pled. Reduce the printed
pages to the number
that can be stapled.
(Refer to page 135.)
WASTE TONER
NEAR FULL The waste toner bot-
tle is nearly full. Prepare a new waste
toner bottle.
HUBS NOT SUPPORTED A USB hub is con-
nected. Do not connect a USB
hub.
DEVICE NOT
SUPPORTED An incompatible
device is connected. Do not connect an
incompatible device.
AUTH TIMEOUT Log off from
IEEE802.1X port
authentication auto-
matically. Set authentication of
IEEE802.1 port again,
and then log on.
PORT AUTH ACTIVE IEEE802.1X port is
processing. Please wait until authen-
tication processing is
completed.
This message... means... do this...