Konica Minolta magicolor 7450 II grafx - Manual (Page 218)

Hard Disk Kit 204
Hard Disk Kit
If a hard disk is installed, fonts can be downloaded and saved, and the over-
lay function can be used.
"
Even if both a hard disk kit and CompactFlash card are installed at the
same time, only one of them can be used.
Installing a Hard Disk Kit
Note
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 201. In addition,
always handle circuit boards by the edges only.
1
Turn off the printer and discon-
nect the power cord and inter-
face cables.
2
Using a coin, remove the screw,
and then lift up the left-side
cover to remove it.