Konica Minolta magicolor 7450 II grafx - Manual (Page 217)

Dual In-Line Memory Module (DIMM) 203
3
Insert the new DIMM straight
into the DIMM connector until
the latches snap into the locked
position.
Observe the keyed side of the
DIMM to align it with the connec-
tor. If you cannot snap the DIMM
into place, do not force it. Repo-
sition it, making sure that the
DIMM is seated completely in
the connector.
4
Attach the left-side cover and tighten the screws.
5
Reconnect all interface cables.
6
Reconnect the power cord, and
turn on the printer.
7
Declare the additional RAM in the Windows printer driver (Properties/Con-
figure tab).
8
Print a configuration page ( PRINT MENU/CONFIGURATION PG ) and
verify that the total amount of the RAM installed in your printer is listed.