Lenovo ThinkServer TD350 - Manual (Page 89)

4. Remove the cooling shroud. See “Removing the cooling shroud” on page 69.
5. To remove the PCIe card holder, press the release tab 1 and carefully disengage the PCIe card holder
from the chassis at the same time.
Figure 37. Removing the PCIe card holder
6. Before you reinstall the PCIe card holder, locate the correct place in the chassis for installing the holder.
Your server comes with two PCIe card holder and there is a mark on the rear of each holder.
• Install the PCIe card holder marked with A to the bracket marked with A in the chassis.
• Install the PCIe card holder marked with B to the bracket marked with B in the chassis.
7. To reinstall the PCIe card holder, note the orientation and the type of the PCIe card holder. Align the
holes in the PCIe card holder with the corresponding mounting stubs on the chassis. Then, slightly
press the PCIe card holder until it snaps into position.
Figure 38. Installing the PCIe card holder
Chapter 6 . Replacing hardware 75