Lenovo ThinkServer TD350 - Manual (Page 85)

To remove and reinstall the front bezel, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Depending on the model, do one of the following:
• Remove the rack handles. See “Removing and reinstalling the rack handles” on page 67.
• Open the front door, and then remove the front door by lifting it slightly upward until you can
completely remove it.
Figure 33. Removing the front door
4. Remove the server cover. See “Removing the server cover” on page 66.
5. Remove all drives, dummy trays, or protective shields. See the related topics in Chapter 6 “Replacing
hardware” on page 63.
Chapter 6 . Replacing hardware 71