Lenovo ThinkServer TD350 - Manual (Page 151)

7. Position the drive adapter and the 2.5-inch drive into the 3.5-inch drive bracket. Align the screw holes in
the drive adapter and the 2.5-inch drive with the corresponding holes in the bracket. Then, install the
five screws to secure the drive adapter and the 2.5-inch drive into the bracket.
Figure 101. Installing the screws to secure the drive adapter and the 2.5-inch drive to the bracket
8. Slide the 2.5-inch drive into the drive bay from the front until it snaps into position, and then completely
close the handle.
Figure 102. Installing the 2.5-inch drive
9. Check the hot-swap-drive status LEDs to ensure that the 2.5-inch drive is operating correctly. You might
have to restart the server for the newly installed 2.5-inch drive to be recognized. See “Hot-swap-drive
LEDs” on page 30. If the 2.5-inch drive is faulty, reinstall or replace it until it is operating correctly.
10. Close the front door (if available).
Chapter 6 . Replacing hardware 137