Connecting cables – Lenovo ThinkServer TD350 User Manual
Page 53
2.5-inch hot-swap-drive backplane
The following illustrations show the connectors on a 2.5-inch hot-swap-drive backplane.
Figure 22. Front view of the 2.5-inch hot-swap-drive backplane
Figure 23. Rear view of the 2.5-inch hot-swap-drive backplane
0
–
7
Slot 0 – slot 7
Used to connect 2.5-inch hot-swap drives.
8
10-pin power connector
Used to connect a power cable to provide power to the backplane.
9
AnyRAID-adapter slot
Used to connect an AnyRAID adapter or a pass-through board.
Connecting cables
This topic provides instructions on how to connect cables:
•
“Connecting the mini-SAS to PCIe signal cable from the system board to the AnyRAID adapter” on
•
“Connecting the SATA signal cable from the system board to the pass-through board” on page 40.
•
“Connecting the easy-swap-drive module to the system board” on page 40.
Connecting the mini-SAS to PCIe signal cable from the system board to the AnyRAID
adapter
This topic applies only to server models that have an AnyRAID adapter installed.
To connect the mini-SAS to PCIe signal cable (hereinafter referred to as the Y cable) from the system
board to the AnyRAID adapter, do the following:
1. Use one Y cable. Connect the dual-in connectors on one end of the Y cable to the PCI-E 0 connector
and the PCI-E 1 connector on the AnyRAID adapter.
39