Lenovo ThinkVantage (Power Manager Deployment) - Manual (Page 35)

Table 2. Power Plan (Scheme) Deployments (continued)
Policy settings Description
Reserve battery alarm level (DC) Specifies the percentage of battery capacity remaining
that triggers reserve power mode.
If you enable this policy setting, you must enter a numeric
value (percentage) to set the battery level that triggers the
reserve power notification.
This setting is supported only on Windows 7 client
computers.
Critical battery alarm level (AC) Specifies the percentage of battery capacity remaining
that triggers the critical battery alarm action.
If you enable this policy setting, you must enter a numeric
value (percentage) to set the battery level that triggers
the critical notification.
Note: The value should be lower than the level specified
by Low battery alarm level.
To set the action that is triggered, see the critical battery
alarm action (AC) policy setting in Table 2 “Power Plan
(Scheme) Deployments” on page 9.
If you disable this policy setting or do not configure it,
users can see and change this setting.
This setting is not supported on Windows XP client
computers.
Critical battery alarm level (DC) Specifies the percentage of battery capacity remaining
that triggers the critical battery alarm action.
If you enable this policy setting, you must enter a numeric
value (percentage) to set the battery level that triggers
the critical notification.
Note: The value should be lower than the level specified
by Low battery alarm level.
To set the action that is triggered, see the critical battery
alarm action (AC) policy setting in Table 2 “Power Plan
(Scheme) Deployments” on page 9.
If you disable this policy setting or do not configure it,
users can see and change this setting.
This setting is not supported on Windows XP client
computers.
Chapter 3 . Working with Active Directory and ADM or ADMX files 29