Kodak D4000 User Manual
Page 31
Troubleshooting
4-3
Paper Cover Open The paper holder is open.
Securely close the paper holder.
Incorrect Rib L
The printer could not read the bar code
on the ribbon on the left, or the wrong
type is loaded.
Check that the ribbon on the left has a bar
code, and/or replace it with the correct type
(see
Incorrect Rib R
The printer could not read the bar code
on the ribbon on the right, or the wrong
type is loaded.
Check that the ribbon on the right has a bar
code, and/or replace it with the correct type
(see
Ribbon Mismatch
The ribbons loaded on the left and the
right are not the same size.
Load ribbons that are the same size
(see
Ribbon Empty L
The ribbon on the left is empty.
Load (or reload) the ribbon on the left
(see
Ribbon Empty R
The ribbon on the right is empty.
Load (or reload) the ribbon on the right
(see
Paper Empty
The paper is empty or is not loaded
correctly. Automatic loading failed.
Load (or reload) the paper (see
Load Paper
The paper is empty or is not loaded
correctly.
Load (or reload) the paper (see
Take Out Paper
The printer detected the end of the
paper and ejected the remainder of the
paper.
Load new paper (see
).
Ready Loading
The printer is preparing to load paper.
No action is necessary.
Control Error
The printer has a specific problem that
may require service.
Turn the printer off. After 10 or more
seconds, turn the printer on and wait for it to
warm up. If the error persists, contact
KODAK Service and Support. Have
available:
• error code number.
• printer model number and serial number
(shown on the data plate on the back of
the printer).
Mecha Error
Sensor Error
TempSensErr
Upper L Jam
The paper is jammed on the left side of
the upper paper path.
Clear the paper jam from the upper paper
path (see
), then reload the paper.
If the error persists, turn the printer off and
then on again.
Upper R Jam
The paper is jammed on the right side of
the upper paper path.
Lower Jam
The paper is jammed in the lower paper
path.
Clear the paper jam from the lower paper
path (see
), and then reload the
paper. If the error persists, turn the printer
off and then on again.
Message
Description or Cause
Possible Solution