Kodak D4000 - Manual (Page 17)

Operating the Printer
2-3
Printer Settings
Use the operator panel buttons to review and change printer
settings.
1. Press Menu to enter Setup Mode.
2. Press Menu repeatedly to scroll through the printer settings.
3. Press +/- to scroll through selections.
4. Press Enter to initiate an action or accept a change.
5. Press Rewind/Unload to exit Setup Mode.
D4000
Duplex Photo Printer
Menu
Enter Rewind/Unload
Advance/Load
Power
Ready
Error
Printer settings are
displayed here 1,2 3
4 5
Display Description
8x10 YMC-YMC
8x12 YMC-YMC
The printer is on and ready to make prints. 8x10 or 8x12 represents
the size of ribbon that is loaded.
Test Print Mode When selected, press Enter to make a test print (see “Making a Test
Print” on page 1-10 ).
Remain = XXX/YYY XXX represents how many remaining prints you can make with the
current paper roll. YYY represents the total number of prints on a
paper roll. The counter is reset each time you press
Rewind/Unload.
Printed = XXXXXX XXXXXX represents the total number of prints made since the printer
was manufactured. This counter cannot be reset.
Donor (L) = XXX[%] XXX[%] represents the percentage of the ribbon on the left that is
available for making prints.
Donor (R) = XXX[%] XXX[%] represents the percentage of the ribbon on the right that is
available for making prints.
MAIN Firm = XX.YY XX.YY represents the version number of the printer control firmware.
DSP Firm = XX.YY XX.YY represents the version number of the image processing
firmware.
TABLE = XX.YY XX.YY represents the version number of the print parameter table.