Kramer Electronics TP-107AVR - Manual (Page 22)

Controlling the TP-107AVR
19
19
6 Controlling the TP-107AVR
The TP-107AVR can be used in a transmitter and receiver system as
described in Section 3.1 , or set up as a controller-less system (see example
in 5.6 Section
You can use the RC-108/RC-116 (see
).
Section 6.1 ) or any other RS-485
based controller 1 6.2 to control the BoardView™ system (see Section
6.1 Controlling the TP-107AVR/TP-122 Kit via the RC-108
).
The RC-108 unit, when connected to a chain of TP-107AVR units, controls
the system by granting access to the projector and overriding the individual
ONLINE buttons on the TP-107AVR units.
If a SELECTOR button on the RC-108 is pressed and held for about two
seconds, the RC-108 loses control over the TP-107AVR units in the chain.
To regain control, press and hold once again.
6.2 Controlling the TP-107AVR/TP-122 Kit via an RS-485 Controller
To control a BoardView™ via an RS-485 controller (see to Section 6.2.1 for
the RS-485 communication Protocol), for example, the Kramer RC-8IR 2
Room Controller, connect the chain of TP-107AVR units to the RS-485
terminal blocks (see Figure 15 ).
1 For example, the Kramer RC-8IR Room Controller
2 Refer to the separate user manual, which can be downloaded at
http://www.kramerelectronics.com