Kramer Electronics VS-44HDCP - Manual (Page 14)

VS-44HDCP - Operating the VS-44HDCP 4x4 DVI Matrix Switcher 11
11
6.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to eight setups and then recall
them as illustrated in Figure 4 .
IN 1 is used for setup number 5 and OUT 1 is used for setup number 1.
Figure 4: SELECTOR Buttons
The numbers (1 to 8) in Figure 4 that illustrate the corresponding
store/recall configuration numbers are for the purpose of illustration
only and do not actually appear on the buttons.
To store a setup:
1. Set the device to the desired setup.
For example, press the OUT 3 button and IN 4 button.
You can set any of the IN-OUT buttons
2. Press the STO button.
The STO button flashes.
3. Select an OUT or IN SELECT button to store the machine setup (for
example, IN 2 for preset 6).
4. Press the LOCK button to store the current setup.
In this example, the IN 2 button stores the setup.
Press the LOCK button within 10 seconds as the store operation times out
automatically after this period.
To recall a setup:
1. Press the RCL button.
The RCL button flashes.
2. Press the relevant OUT or IN button that stored the setup.
In this example, press IN 2.
3. Press the LOCK button to recall the stored setup.
i