Kramer Electronics VP-161xl - Manual (Page 13)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting an XGA / Audio Switcher
10
6 Connecting an XGA / Audio Switcher
To connect the VP-81xl 1 , unit, as illustrated in Figure 4, do the following 2 :
1. Connect up to eight VGA/XGA computer graphics sources to the HD15F
INPUT connectors (from 1 to 8).
2. Connect the balanced audio sources (see section 6.1) to up to eight INPUT
terminal block connectors (not shown in Figure 4)
3. Connect the OUTPUT connector to a VGA/XGA acceptor (for example, a
projector).
4. Connect the balanced audio terminal block connector (see section 6.1) to an
acceptor (not shown in Figure 4).
5. Set the dipswitches (see section 6.4)
6. As an option you can connect a PC and/or controller to the:
RS-232 port (see section 6.2)
RS-485 port (see section 6.3)
7. If required, connect remote contact-closure switches to the REMOTE
terminal block connector (see section 6.5)
8. Connect the power cord 3 .
1 The same connecting principles apply to the VP-161xl (16 inputs) and the VP-321xl (32 inputs)
2 Be sure that the power is switched OFF on each device before connecting it to your unit(s). After connecting all the devices
to your unit(s), switch on the power of the unit(s), and then switch on the power of each device
3 We recommend that you use only the power cord that is supplied with this machine