Kramer Electronics TP-124 - Manual (Page 28)

Configuring a TP-105 CAT 5 Line Driver/DA
25
25
11 Configuring a TP-105 CAT 5 Line Driver/DA
You can connect the TP-105 CAT 5 Line Driver/DA—using a PT-110 XGA
Line Transmitter and two TP-120 XGA Line Receiver 1
To connect the TP-105, as the example in
units—to transmit a
computer graphics signal to two displays via long line CAT 5 UTP cabling.
Figure 17 illustrates, do the
following:
1. On the PT-110, connect the:
 Computer graphics source to the XGA INPUT 15-pin HD (F)
connector
 LINE OUTPUT RJ-45 connector 2
2. On the TP-105, connect the:
to the INPUT RJ-45 connector
on the TP-105
 OUT 1 RJ-45 connector to the LINE IN RJ-45 on the first
TP-120
 OUT 2 RJ-45 connector to the LINE IN RJ-45 on the second
TP-120
3. On the two TP-120 units, connect the:
 XGA OUT 15-pin HD (F) connector on the first TP-120 unit to
the XGA acceptor (for example, Display 1)
 XGA OUT 15-pin HD (F) connector on the second TP-120 unit
to the XGA acceptor (for example, Display 2)
4. On each of the four Kramer units, connect the 12V DC power adapter to the
power socket and connect the adapter to the mains electricity.
The signal from the XGA source is transmitted via the two CAT 5 cables,
decoded and converted at the each of the XGA OUT 15-pin HD (F)
connectors to the XGA acceptors.
5. If necessary:
 Adjust 3
 Set the H SYNC and V SYNC switches
the video output signal level and/or cable compensation
equalization level on the TP-105 and on both the TP-120 units
4
1 Refer to the separate user manual: PT-110, WP-110, TP-120, which can be downloaded from the Internet at
on the underside of the
TP-120 units
http://www.kramerelectronics.com
2 Via UTP cabling (with a range of more than 300ft (>100m)). For details of how to wire a CAT 5 LINE IN/LINE OUT
RJ-45 connector, see section
8.1
3 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
4 By default, both switches are set down (for negative V SYNC and H SYNC polarity)