Festo Контроллер крайних положений SPC11 - Manual (Page 24)

1. Installation instructions for the DNCI or DDPC
1-10 Festo P.BE-SPC11-DNCI-EN en 1208a English
Coupling (
7 )
If a coupling is required between the piston rod and the
guide:
• Check the play of the coupling.
The following applies here: Coupling play ≤ 0.05 mm
• Set the play of the coupling accordingly.
Please note
If the coupling play is too large, it may not be possible to
carry out the teach procedure successfully. If there is too
much coupling play this may cause:
– noise due to knocking on the coupling
– increased wear of the couplng
– deterioration in running behaviour.
Make sure that the coupling play does not exceed
0.05 mm.