Festo Контроллер крайних положений SPC11 - Manual (Page 17)

1. Installation instructions for the DNCI or DDPC
1-3 Festo P.BE-SPC11-DNCI-EN en 1208a English
1.1 General instructions
Warning
Faults in the system structure and incorrect parameters
can cause the piston to move to an end position uncu-
shioned. The fixed stop or the drive may then be de-
stroyed. You must observe the following instructions in
order to prevent such damage.
• Set up the system with great care. Always observe the
safety instructions and information in this manual as well
as in the system manual for type P.BE-SPC11-SYS... .
• Use only the special matching components from Festo for
setting up and wiring the system. Only in this way can you
guarantee the correct functioning of the system.