Festo Контроллер крайних положений SPC11 - Manual (Page 12)

Contents and general instructions
X Festo P.BE-SPC11-DNCI-EN en 1208a English
Notes on the use of this manual
This manual contains special information on installing and
commissioning the SPC11 in conjunction with standard
cylinder type DNCI-... .
Please note
The parameter values and average positioning times listed
in chapter 2 apply
only to the specified nominal stroke
lengths. You can request relevant information for other
nominal stroke lengths.
The SPC11 is available in different designs. In this manual the
SPC11 with multipin connection is described as an example.
Detailed information on the different designs can be found in
the relevant system manual for the SPC11.
General information on the method of operation, fitting, in-
stalling and commissioning pneumatic drives with the SPC11
can be found in the system manual P.BE-SPC11-SYS-... .
Manuals for the SPC11
Manual Title Contents
System manual
Soft Stop SPC11 electronics/pneumatics P.BE-SPC11-SYS... General instructions on installing
and commissioning
Drive-specific supplement for operating
the SPC11 with a certain drive, e.g. with
the DNCI-... (e.g. this manual) P.BE-SPC11-...-... Special installation and commis-
sioning instructions as well as para-
meter settings for the appropriate
drive
1)
1)
These manuals contain the permitted drive-valve combinations, drive diameters and mass loads as
well as the parameter settings valid here for the SPC11.