Muxlab LongReach II Active CCTV Receiver Hub - Manual (Page 8)

© MuxLab. LongReach II Active CCTV Receiver Hub Installation Guide
Page 8
Specifications (Cont’d)
RJ45 Pin
Configuration Signal 500022 Mode 500024/500029
Mode
*Reverse polarity
sensitive if 12DC
camera is used *Power A (+) 1, 3 1, 3, 5
*Power B (-) 2, 6 2, 4, 6
Control (+) 4 NA
Control (-) 5 NA
Video BNC Center
(Tip) 7 [T] same as
500000R 7 [T] same as
500000R
Video BNC Ground
(Ring) 8 [R] same as
500000R 8 [R] same as
500000R
Connectors Video Out: BNC-F (8 or 16)
Remote Power: 2-pole screw terminal
block (8 or 16)
PTZ: 2-pole screw terminal block (8 or
16)
Cat5e/6 Link: RJ45S (8 or 16)
Power connector.GND screw terminal
Power Supply (included)
Current drawn per unit
5VDC 2.6 A max. Floating.
Interchangeable blades
500126 (8-port): 0.79 A max.
500127 (16-port): 1.53 A max.
Transient Voltage Protection ± 2.5V on the video line
± 48V on the power and control lines
AC/DC power surge protection Above 34VAC RMS or +/-48 VDC.
Fuse Protection Auto-resettable fuses on 5VDC input
and Power A (+) upon power cycling.
Temperature Operating: 0° to 55°C. Storage:-20° to
85°C. Humidity: up to 95%