Vaddio TrackVIEW - Manual (Page 7)

TrackVIEW Install Guide 341-337 Rev. G Page 7 of 30
TrackVIEW and Peripherals Install Guide
INSTALLING THE CAMERAS
The TrackVIEW Base System includes only the reference camera and wide-angle lens. The reference camera
can be one of the following cameras provided the cabling is correct (see Appendix A – system pin-outs):
 Sony
EVI-D100
 Sony
EVI-D70
 Sony
EVI-HD1
No other unitized pan/tilt/zoom cameras will operate with the TrackVIEW.
The TrackVIEW 70 System
The TrackVIEW 70 system includes the Vaddio Dual Camera Thin Line Wall Mount that mounts the cameras in
a vertical array to minimize the space between the cameras and make mounting the cameras very fast and easy
(see Figure 5). The dual camera wall mount will fit all the TrackVIEW 70 and TrackVIEW 100 dual camera kits
(see Figure 6). Both cameras use the EZCamera cabling shoe and are powered from the TrackVIEW controller.
Figure 5:
EVI-D70 Reference camera and Tracking
Camera (Platinum white only) with Dual
Thin Line Wall Mount and EZCamera
cabling shoes and wide angle lens on top
camera (reference camera).
The reference camera can be mounted
on top (as shown). The performance of
the system is enhanced by the vertical
position.
A slot in the back of the top shelf allows
for cabling management and the slots in
the top will accommodate both the EVI-
D70 or EVI-D100 PTZ cameras.
Note: Use only the ¼”-20 camera mounting
screws provided, using longer camera mounting
screws will damage the camera an void the
warranty.
Figure 6:
Dual Thin Line Wall Mount
fits EVI-D70 and EVI-D100
Cameras with EZCamera
cabling shoes.
The dual mount is shipped
platinum white only and
mounts to a 2-gang wall
box or with wall anchors.