Vaddio TrackVIEW User Manual
Page 10
TrackVIEW Install Guide 341-337 Rev. G
Page 10 of 30
TrackVIEW and Peripherals Install Guide
TrackVIEW HD1 System Connections
The TrackVIEW HD1 tracking camera is not connected the same way as the other TrackVIEW Systems. The
reference EVI-D70 camera is connected to the TrackVIEW Controller with Cat. 5 cables for video/power and
control. For setting the 15V/18V switch for the reference camera and maximum cabling distances for the
Video/Power Cat. 5 cable (see Table 1). The EVI-HD1 does not draw power from the TrackVIEW controller. It
is supplied power from its own Quick-Connect PRO, EZIM and 36VDC power supply (see Figure 10). The EVI-
HD1 uses Cat. 5 cables for Video and Power (2) from the Quick-Connect PRO and a 3
rd
Cat. 5 for Control.
Connect the main video output, SD or HD, to the main video monitor or codec and the reference video out to the
reference monitor.
Figure 10:
TrackVIEW HD1 System with cameras connected to the TrackVIEW Controller with Cat.
5 cables. The reference monitor is connected with standard S-Video or composite video
cables.
Cat. 5 for
Video/Power
Cat. 5 for
Control
Cat. 5 for Control
Reference
Monitor
TrackVIEW Controller – Rear Panel
EVI-D70
with Shoe
S-Video
36VDC
Power
Supply
HD Video to HD
Monitor/Codec
Quick Connect PRO
Video
(HD or SD)
Power
Note: See WallVIEW HD1 Operation Manual
for Installation Assistance