Connect to the console port, Access the command line interface, Figure a-1. connect to the console port – ADC MM701G2 User Manual
Page 90
Appendix A: Command Line Interface Access
A-2
C
ONNECT
TO
THE
C
ONSOLE
P
ORT
Access the Command Line Interface
You can access the command line interface through the direct connection to the modem console port using a
terminal emulation program. You can also access the command line interface using a telnet session. To use a telnet
session, you must have IP access to the modem either through the 10/100Base-T LAN port (LAN-side access) or
through an IP address assigned to a WAN session (WAN-side access). The following sections provide instructions
for setting up both types of command line interface access.
Step
Action
1
Install the flat gray console cable between the modem Console port and your PC (see
), using
the DB-9 port adapter on the PC, if required.
Figure A-1. Connect to the Console Port