ADC MM701G2 - Manual (Page 115)

April 14, 2006 Appendix A: Command Line Interface Access
MM70xG2-UM-03 A-27
R ESTORING F ACTORY D EFAULTS
When you configure the modem, you change the factory default settings to new values. You can return these
parameters to their default values to provide a known starting point if you are troubleshooting or you simply want to
configure new parameters. For session default values, see
“Default Session Parameter Values” on page B-4 .
There are three ways to reset the modem to its factory default values:
• Using the Command Line Interface (below)
• Using the Web Interface (see “Reset to Factory Defaults using the Web Interface” on page 9-13 )
• Using the modem’s Reset button (see “Reset to Factory Defaults using the Reset Button” on page 9-14 )
Restoring Factory Defaults
!
IMPORTANT
Active links are lost when you reset to factory default values.
Step Action
1 From the System Management menu, enter 6 to Restore Factory Configuration ( Figure A-21 ).
Figure A-21. Restoring Factory Defaults
2 Do one of the following at the prompt:
• Enter Y if you want to return all values to their original factory values.
• Enter N if you do not want to return all values to their original factory values.