ADC MM701G2 User Manual
Page 112
Appendix A: Command Line Interface Access
A-24
2
View the current statistics, as described below:
• Operational State
Indicates the current mode of the modem. Operational states include:
– Handshaking—indicates that the modem is negotiating with the DSLAM or the other modem
– Training—indicates that the modem is learning the connection parameters
– Show time—indicates the G.shdsl connection is operational
• Data Rate
Indicates the bit rate for this transmission on the G.shdsl connection.
• DSP Version
Identifies the version of G.shdsl firmware driver used for this modem.
• Transmission Power
Indicates the local transmission power in decibels.
• Receiver Gain
Indicates the amplifying factor for incoming signal in decibels.
• Local SNR Margin
Indicates the current value for the SNR margin in decibels.
• Loop Attenuation
Indicates the current and approximate loop attenuation (loop signal loss) in decibels.
• Framer Sync
Indicates the current status of G.shdsl framer synchronization.
Step
Action