Step 6: start dryer indicator lights – Alliance Laundry Systems D677I User Manual

Page 43

Operation

512680

Step 6: Start Dryer

To start dryer, push START pad.
To stop dryer at any time, open the door. To restart the

dryer, close door and push START pad.
Cycle is completed when time remaining reaches

00 minutes.

Figure 57

Indicator Lights

INSERT COINS
INSERT COINS is lit to prompt the user to insert coins

or card to satisfy the vend price for the chosen cycle.

When INSERT COINS is lit, the three digits and

decimal point will display the vend price remaining to

be satisfied.
PUSH START
PUSH START is lit whenever the dryer is not in a

cycle, the full vend price has been satisfied and the

dryer door is closed. When the START pad is pressed,

the cycle will begin or resume. The PUSH START

status word flashes at one-second intervals when

activated.

DRYING
DRYING is lit to indicate that one of the heated cycles

(HIGH TEMP, MED TEMP, LOW TEMP) is currently

in operation. The status word DRYING goes off at the

end of a heated cycle or when the COOL DOWN cycle

begins.
DOOR OPEN
DOOR OPEN is lit and flashes at one-second intervals

whenever the dryer door is open.
COOL DOWN
COOL DOWN is lit whenever the COOL DOWN

portion of a heated cycle is active. It is also lit when

the NO HEAT cycle is in operation.
PRICE
PRICE is lit to indicate that the value displayed is the

vend pricing remaining to be satisfied. Once the vend

price is satisfied, the word PRICE will go off.
TIME REMAINING
TIME REMAINING is lit to indicate that the time

displayed by two digits and the colon is the time

remaining (in minutes) in the active cycle. The colon

flashes at one-second intervals and time continually

counts down in an active cycle.
Should dryer stop before cycle is completed, the motor

overload protector may have cycled. Refer to

Maintenance section.

D296I