American Dynamics ADCTDN0230P - Manual (Page 13)

13
D [IRIS] Iris Terminal
This is connected to an autoiris control lens.
E [VIDEO,DC] Iris Selector Switch
This should be set according to the type of lens if an autoiris control lens is
used.
VIDEO
: In case of lens with EE amp built-in
DC : In case of lens without EE amp built-in
(Default setting: DC)( A Pg. 18)
F [LEVEL] Iris Level Adjustment Dial
This adjusts the iris level of the autoiris control lens. Usually, adjustment is not
required. When it is necessary, adjust the iris level according to the condition
of the object. (
A Pg. 28)
To darken : Anti-clockwise direction (Towards L)
To brighten : Clockwise direction (Towards H)
G Rotation-preventive hole
Make use of this rotation-preventive hole to prevent any fall when mounting
the camera. Always make sure that the camera is securely mounted.
H Camera-mounting screw hole (1/4-20UNC)
Use this hole when mounting the camera onto a mount, pan/tilt unit and the
like. Use a screw shorter than 7 mm. (
A Pg. 23)
Note:
● Do not use a screw that is longer than the specified length. It may damage
the internal parts.
I Camera-mounting bracket
The bracket has been attached on the bottom of the camera before shipment.
It can also be attached on the top according to the circumstance. (
A Pg. 24)
J [BF LOCK] Back focus locking screw
This serves to lock the back focus adjustment mechanism. ( A Pg. 26)
ADCTDN2412N_P_EN.book Page 13 Friday, September 28, 2007 12:49 PM