Sony KLV-32M1 - Manual (Page 26)

26
VHF/UHF
CENTER SPEAKER
IN
180W (6 ) MAX
VIDEO IN
HD/DVD IN
AUDIO OUT
(VAR/FIX)
VIDEO
P B Y L R P R
S VIDEO AUDIO
AUDIO
1
3
4
R L (MONO)
R L
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
S VIDEO
Rear of TV
75-ohm coaxial
cable (supplied)
S VIDEO
cable
(not supplied)
A/V cable (not supplied)
Satellite
antenna
cable
Satellite Receiver
Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2
Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO and
S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 3 IN).
Tip
If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV’s VHF/UHF jack.
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page
25).
Tips
• You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your
satellite receiver.
• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use
the VIDEO 3 IN jacks for this hookup) to watch satellite TV.