Sony KLV-32M1 - Manual (Page 13)

13
Installing the TV
Installing the TV
Unpacking
When you unpack this unit, make sure it includes the
following:
Clamp Screws (2)
Operating Instructions (1)
Quick Setup Guide (1)
Warranty Card (1)
AC power cord (1)
75-ohm coaxial cable (1)
Remote control (1) and
size AA batteries (2)
Overview of the Remote
Control
Insert two size AA batteries (supplied) by matching
the e and E on the batteries to the diagram inside
the remote control’s battery compartment.
Notes
• Remove the batteries to avoid damage from possible battery
leakage whenever you anticipate that the remote control will
not be used for an extended period.
• Handle the remote control with care. Avoid dropping it,
getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.
• The supplied remote control can be programmed to operate most
video equipment (see “Programming the Remote Control” on
page 16).