Avaya 1200 - Manual (Page 38)

Getting started
38
If you insert the foot stand into the lower slots, your IP Deskphone sits at
a 55-degree angle.
1. Align the bottom tabs on the foot stand with the position 1 slots or the
position 2 slots on the back of your IP Deskphone.
In position 1, the IP Deskphone sits at a 25-degree angle.
In position 2, the IP Deskphone sits at a 55-degree angle.
Figure 3 on page 37 shows the slots on the back of the IP
Deskphone.
2. Press the foot stand into the slots until it snaps into place.
Note: If you mount your IP Deskphone on a wall, do not attach the
foot stand.
Connecting the handset
Use the following procedure to connect the handset to your IP
Deskphone:
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the handset symbol as shown
Figure 3 on page 37 .
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.
Connecting the headset (optional)
You can connect a headset to the IP Deskphone as described in the
following procedure:
1. Plug the headset cord into the headset jack on the back of the IP
Deskphone as shown in
Figure 3 on page 37 .
2. Thread the cord through the channel in the side of the foot stand (if
installed).
3. Set up the headset according to the headset instructions.