Karcher B 60 W Bp Pack Dose User Manual
Page 11
-
4
Î
Remove the brushes from the appli-
ance as described in the appliance's
operating instructions.
Î
Remove the cleaning head from the ap-
pliance (see operating instructions).
Î
Place the cleaning head vertically and
protect from tipping over.
Î
Remove coarse dirt from the bottom
side and the splash-guard by hand.
Î
Remove encrusted dirt with a plastic
scraper or with a high pressure cleaner.
Caution
Risk of damage. Use a scraper made from
unbreakable and non-abrasive plastic.
Î
Spray the residual dirt with a high-dose
alkaline detergent solution (spray bot-
tle, KÄRCHER RM 750, 30 %).
Î
Allow detergent solution to soak in for a
at least 15 minutes.
Do not let the detergent dry on, respray
if necessary.
Î
Rinse the bottom side with a strong wa-
ter jet.
Î
Let the cleaning head dry completely.
Tip
The cleaning effect can be enhanced by
using a hot water high pressure cleaner.
Observe the spray distance to prevent
damage.
Î
For the safe elimination of bacteria, we
recommend spraying the bottom side
and the splash-guard with a disinfecent
(e.g. KÄRCHER disinfectant RM 732).
Important
Observe the directions provided by the
manufacturer of the disinfectant.
Î
Empty dirt pan after each cleaning.
Î
Spray the coarse dirt out of the dirt pan
with water (if necessary, preclean with a
clean cloth).
Î
Spray the residual dirt with a high-dose
alkaline detergent solution (spray bot-
tle, KÄRCHER RM 750, 30 %).
Î
Let the detergent solution soak for 10 to
15 minutes.
Î
Rinse the residual dirt with a strong wa-
ter jet.
Î
Let the dirt pan dry.
Î
For the safe elimination of bacteria, we
recommend spraying the dirt pan with a
disinfecent (e.g. KÄRCHER disinfect-
ant RM 732).
In order to optimise the reduction of the
bacterial and dirt migration between the
scrubber brush and the floor covering, we
recommend a 2-step method.
Step 1:
Î
Scrubbing with simultaneous coating
with suitable detergent. (Observe the
dosing required by manufacturer.)
Î
Allow detergent solution to soak in (be-
tween 5 and 15 minutes).
Do NOT let the detergent dry on. Re-
spray with detergent if necessary.
Step 2:
Î
Scrubbing with minimum detergent
coating (reduced water volume) with si-
multaneous vacuuming of dirt.
Î
Optimum: Rescrubbing/clear rinsing of
the floor surface with fresh water with
simultaneous vacuuming of dirt.
The following table is to be used as a guide-
line for different floor covering contamina-
tion. Adaptation of the values for the
actually present floor covering as well as
the current contamination may become
necessary.
Bottom side and splash-guard
Coarse dirt pan (BR model only)
General note for the cleaning
of floor coverings as per
HACCP basics
Adaptation to different floor and contamination types.
Type of contamination
Water quantity
Detergent dosing
Driving speed
Dust, loose, superficial dirt, easily soluble.
Dried on liquids, food residue, etc.
Strongly adhered, encrusted food products
such as pasta, sugar-based foods, meat resi-
due, etc.
Approx. 5 % mix-
ture in the fresh
water reservoir
You can request detailed cleaning instructions for different floor coverings if needed.
11
EN