Printing instructions (cont'd.) – HID ProxCard Handling Guide User Manual
Page 4

.125"
.317 cm
.450"
1.143 cm
.125"
.317 cm
.450"
1.143 cm
.125"
.317 cm
PRINTING INSTRUCTIONS (Cont'd.)
The drawing below outlines the recommended print area on
the card. Some printers are capable of full-bleed or
edge-to-edge printing. HID recommends that you run some
test cards on your printer before designing your graphics for
edge-to-edge printing. Also, most printer manufacturers
discourage printing on cards which are pre slot punched,
as the slot edge may tear the printer ribbon or interfere with
the end-of-card sensor and stop the printing process.
Print your cards first, then slot punch them. If your cards are
already punched, do not print in the area near the slot (dark
hatched area in diagram below).
We hope these suggestions will help you
successfully print on your HID cards.
HID Corporation, Irvine
9292 Jeronimo Road
Irvine, CA 92618-1905
Tel: (800) 237-7769
Fax: (949) 598-1690
www.HIDCorp.com
HID Corporation, CT
333 State Street
North Haven, CT 06473
Tel: (800) 243-2563
Fax: (203) 407-5990
www.HIDCorp.com
Page 4
PRINT AREA
(unless card is slot punched)
Do
NOT print this area if card is slotted on this edge.
Do
NOT print this area if card is slotted on this edge.
- bioCLASS Installation Guide (12 pages)
- Crescendo Integration (54 pages)
- EDGE EVO EDM-M Door Module Installation Guide (4 pages)
- EDGE EVO EDWM-M Door-Wiegand Module Installation Guide (4 pages)
- EDGE EVO EH400 Hi-O Controller Installation Guide (12 pages)
- EDGE EVO Solo ESH400 Hi-O Controller Installation Guide (12 pages)
- EDGE EVO EH400-K Standard Controller Installation Guide (12 pages)
- EDGE EVO Solo ESHR40 Hi-O Controller/Reader Installation Guide (12 pages)
- EDGE EVO EIM-M Hi-O Input Module Installation Guide (2 pages)
- EDGE EVO EIM-M Input Module Installation Guide (2 pages)
- EDGE EVO ELM Hi-O Lock Module Installation Guide (2 pages)
- EDGE EVO ELM Lock Module Installation Guide (2 pages)
- EDGE EVO EVM Hi-O Voltage Module Installation Guide (2 pages)
- EDGE EVO EVM Voltage Module Installation Guide (2 pages)
- EDGE EVO Hi-O Interface Door Module Installation Guide (4 pages)
- EDGE EVO Solo ESH400-K Networked Controller Installation Guide (10 pages)
- EDGE EWM-M Hi-O Wiegand module Installation Guide (4 pages)
- EDGE Plus Installation Guide (2 pages)
- EntryProx Installation Guide (58 pages)
- MIFARE Reader Installation Guide (6 pages)
- Hi-O iCLASS Installation Guide (49 pages)
- iCLASS Keypad Installation Guide (12 pages)
- iCLASS R Installation Guide (12 pages)
- iCLASS RK Series Rev C Installation Guide (12 pages)
- iCLASS SE Installation Guide (10 pages)
- iCLASS SE/ multiClass SE Installation Guide (10 pages)
- Magnetic Stripe / Prox Reader 230 and 240 Installation Guide (2 pages)
- Magnetic Stripe Reader 644 Installation Guide (2 pages)
- Magnetic Stripe Reader 740 Installation Guide (2 pages)
- Magnetic Stripe Reader 780 Installation Guide (2 pages)
- MaxiProx Installation Guide (19 pages)
- multiCLASS / Magnetic Stripe Installation Guide (12 pages)
- multiCLASS / Magnetic Stripe with Keypad Installation Guide (10 pages)
- multiCLASS RP Series Hi-O Installation Guide (6 pages)
- pivClass Installation Guide (8 pages)
- Prox Programmer Installation Guide (21 pages)
- ProxPass Installation Guide (3 pages)
- ProxPoint Installation Guide (3 pages)
- ProxPoint Plus Installation Guide (2 pages)
- ProxPro II Installation Guide (2 pages)
- ProxPro Installation Guide (14 pages)
- Serial ProxPro Reader Installation Guide (10 pages)
- SmartID Mounting Plate Installation Guide (2 pages)
- SmartID Spacer Installation Guide (2 pages)
- VertX EVO V1000 Installation Guide (19 pages)