Nikon 5000 - Manual (Page 125)

Taking Photographs—Advanced Photography
111
Viewing the Current Continuous Setting
At settings other than Single, the current “continu-
ous” setting is indicated by an icon in the monitor.
Noise Reduction
When NOISE REDUCTION is on or set to Clear Image Mode ( 128), CON-
TINUOUS is automatically set to Single, and the options in the CONTINUOUS
menu are disabled.
Movie/Ultra HS
Settings of Movie and Ultra HS only take effect when the monitor is on. If
the monitor is turned off, the camera will revert to a setting of Single until
the monitor is turned on. If the monitor is swivelled to point in the same di-
rection as the lens, the display in the monitor will be inverted.
Using Zoom while Recording Movies
In Movie mode, optical zoom can only be adjusted before recording begins.
Digital zoom can also be adjusted before recording in the range 1.2
×
to 2.0
×
(values of more than 2.0
×
are not available in Movie mode). Once recording
has started, pressing the zoom button triggers digital zoom, even if Off has
been selected in the setup Zoom Options > Digital Tele menu (
151). The
zoom settings available in Movie mode are summarized in the following table:
Before recording During recording
Optical
zoom
Can be adjusted normally.
Fixed at position selected before
recording.
Digital
zoom
1.2 – 2.0
×
from maximum opti-
cal zoom position.
Up to 2.0
×
from current optical
zoom position. *
* If digital zoom was in effect before recording began, digital zoom can be ad-
justed freely up to 2.0
×
from the maximum optical zoom position.