Swiftech H20 120 - Manual (Page 22)

Parts list
Parts QTY PARTS QTY
MCW6000-P™ water-block 1 Retention clips 2
Worm drive clamps 2 SP4 hold-down plate 1
1. Preparing your Motherboard
Remove the existing heat sink
Carefully clean the CPU.
Lightly coat the CPU with thermal compound. We recommend high quality thermal compound such as Arctic Silver or equivalent.
Application will vary depending on the type of processor. We recommend visiting www.arcticsilver.com for detailed instructions.
2. Water-block orientation
For ease of operations during bleeding, the outlet should always be at the highest point (while system is standing upright):
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at
www.swiftnets.com for
updates.
b
ITEM NO. QTY. PART NO. DESCRIPTION
1 1 S478 Intel Pentium 4 socket 478 motherboard and processor
2 1 MCW6000-P-with-bracket MCW6000-P water-block assembly
a 1 MCW6000-FLAT MCW6000 waterblock flat base
1 SP4-Bckt SP4 Hold-down plate for Intel Pentium 4 and Xeon
3 2 SC478 Pentium 4 spring clip
3
1
INLET
DISCHARGE
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-12009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 9-11-04 – Subject to revision without notice - 22 of 39 -