Swiftech MCW60 T User Manual

Page 5

Step 7

Step 8

Push the gasket down the posts until it mates with the board and

then remove the peel-off paper

Push the MCW60-T assembly down the posts until it

mates with the GPU

Step 9

Step 10

Place the spring, nylon tension limiter and thumbnuts on each

post.

Gradually fasten the thumbnuts until you feel that the

nylon tension limiter is preventing the spring from

compressing further. Do not over tighten!

Mechanical installation is now complete!

Electrical Installation

IMPORTANT WARNING: Solder joints of the wires to the thermoelectric module are extremely fragile. Bending the
wires at their root will break the solder joint, with no possible repair. Swiftech will not honor the warranty for broken
wires.

Thermo-electric modules characteristics:

The Peltier module used with your MCW60-T can be safely operated from 12 to 19.3 Volts.

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:

[email protected] – URL:

http://www.swiftnets.com

- Information subject to change without notice