Swiftech MCW60 T - Manual

One or more Patents pending
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation
may result in damage to your components. Swiftech™ assumes no liability whatsoever, expressed or implied, for the
use of these products, nor their installation. The following instructions are subject to change without notice. Please visit
our web site at
www.swiftnets.com for updates.
ITEM NO. PART NUMBER DESCRIPTION QTY
.
1 77706 2-56-thumb-nut 4
2 SCREW INSULATOR10SC004025 tension limiter 4
3 70700S spring 4
4 mcw60-housing-rev2 housing 1
5 MCW60-HOLD-DOWN-PLATE hold-down plate 2
6 MCW60-BP-T base plate 1
7 40mm Peltier module 1
8 MCW60-CP-T Cold plate 1
9 MCW50-T-B2 gasket 1
10 MCW60-T-GSKT1 gasket 1
11 MCW60-T-GSKT4 gasket 1
12 MCW50-T-MB125 gasket 1
1
2
3
4
5
6
7
8
9
10
12
5
11
BEFORE YOU BEGIN: Please remove the existing cooling solution from the graphics card, and carefully clean
off the GPU with an electronics degreaser (Xylene is recommended).
Copyright Swiftech 2006 – All rights reserved – Last revision date: 5-15-06 – One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:
[email protected] – URL: http://www.swiftnets.com - Information subject to change without notice