Swiftech APOGEE DRIVE II - Socket 2011 User Manual
Page 5
Copyright Swiftech 2012
– All rights reserved – Last revision date: 6-6-12 - Rouchon Industries, Inc., dba Swiftech® –151 West Victoria Street, Long Beach, CA 90805 – Tel.
310-763-0336 - Toll free (US) 888-857-9438
– Fax 310-763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com - Information subject to change without notice
Pump operating precautions
The MCP35X™™ pump should never be run dry, even for a quick test. You should always prime the pump with fluid
before you start operating it: see warranty note (*).
Use of coloring dies or fluorescent additives containing particulate fillers will cause excessive wear to the pump’s impeller
bearing: see warranty note (**)
Pump Specifications
Motor type
Electronically commutated, brushless DC, spherical motor
Nominal voltage
12 V DC
Operating voltage range
9 to 13.4 VDC
Max. nominal power (@12 V)
18 W
Max. nominal current (@12 V)
1.5 A
Max. nominal head (@12 V)
14.7 ft (4.4m)
Max nominal discharge (@12 V)
Max nominal discharge (@12 V)
Maximum pressure
22 PSI (1.5 BAR)
Temperature range
Up to 140°F (60°C)
Electrical power connector
Molex 4 pin
PWM + RPM signals
4-pin connector
ROHS
Compliant
Port thread standard
G1/4
MTBF
50,000 Hours
Always double-check that fittings & plugs are correctly fastened to the block. The correct torque using a 5/8 (16mm)
socket is ¼ turn past the point where the fitting is mated to the block surface.
ALWAYS TEST YOUR WATER-BLOCK FOR LEAKS PRIOR TO POWERING-UP YOUR COMPUTER!
DISCLAIMER:
While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech® assumes no liability expressed or
implied for any damage(s) occurring to your components as a result of using Swiftech® cooling products, either due to mistake or omission on our part
in the above instructions, or due to failure or defect in the Swiftech® cooling products. In addition,
Swiftech™ assumes no liability, expressed or
implied, for the use of this product, and more specifically for any, and all damages caused by the use of this product to any other device in a personal
computer, whether due to product failure, leak, and electrical short, and or electro-magnetic emissions.
WARRANTY: This product is guaranteed for a period of 24 months from date of purchase for defects in material, and workmanship. Guarantee
consists of replacing defective parts with new or reconditioned parts. Guarantee is considered void in case of improper use (*)(**), handling or
negligence on the part of user. Original invoice showing date and place of purchase is required for exercise of the warranty.
(*) WARNING: DO NOT ATTEMPT TO RUN THIS PUMP DRY. THIS WILL CAUSE IMMEDIATE AND PERMANENT DAMAGE TO THE PUMP.
(**) EXCESSIVE WEAR DUE TO INADEQUATE FLUIDS.
During this period, they will be repaired or have parts replaced provided that: (I) the product is returned to the agent from which it was purchased; (II)
the product has been purchased by the end user and not used for hire purposes; (III) the product has not been misused, handled carelessly, or other
than in accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out
above and does not cover any claims for consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory
rights as a consumer.