Swiftech FS020 ALL MODELS - Manual (Page 4)

Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Subject to change without notice - 4 -
BEFORE YOU BEGIN!
Components installation
1. Open the side-panel #21 by loosening thumb screws #32
2. Remove the main cross bar #27.
3. A special memory board cross bar (#37) specific to server applications is provided with the lose parts. It is not shown in the schematic above,
and can be safely discarded in most consumer applications.
4. Loosen screw #33, and remove the front bezel #1
5. Remove the top cover #17
You now have full access inside the case to proceed with the installation of your power-supply, motherboard, hard drive (s) and various components.
Pre-installation notes
•
Your cooling circuit is already filled with coolant (95% pure water, 5% Swiftech’s HydrX

high-performance coolant). All you need to do is to
install the water-block to your CPU. Please follow the separate installation guides for AMD

or INTEL

processors.
•
Power to the pump: a spare power cord is provided to supply A/C power to the pump. It needs to be connected to an A/C outlet.
•
Your QuietPower

case ships from the factory pre-configured to order. All you need to do is install your components.