Swiftech FS020 ALL MODELS User Manual
Page 13
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Subject to change without notice
- 13 -
1.
Open valve 2 for a couple of seconds, to allow any
air trapped into the valve to escape. Close valve 2
again.
2.
Now, close valves 3 and 1, and open valve 2.
The system is now full, bled, and ready to use,
as shown in the picture to the right.
3.
Turn off the pump by disconnecting it from
A/C.
4.
With both tubes still inside valves 1 and 3,
carefully place the holding tank below the
computer (on the floor for example)
5.
Disconnect the tubes from valves 1 and 3.
Whatever little liquid was still trapped in the
tubes will flow back into the holding tank
without making a mess :-)
6.
FINALLY, REMEMBER to reconnect the L
wire from the socket to the N\O position on the
switch !
- Intentionally left blank -
- MCX159 (2 pages)
- MCX159 CU (4 pages)
- MCX159 P (2 pages)
- MCX159 R (2 pages)
- MCX V PRO (4 pages)
- MCX VCORE (3 pages)
- MCX370 (2 pages)
- MCX4000 (2 pages)
- MCX462 (2 pages)
- MCX462 (5 pages)
- MCX462 U (4 pages)
- MCX462 V (2 pages)
- MCX478 (2 pages)
- MCX478 V (2 pages)
- MCX603 R2 (2 pages)
- MCX603 V (4 pages)
- MCX603 V 1-10-04 (3 pages)
- MCX603 VSR2 (2 pages)
- MCX604 V (2 pages)
- MCX64 V (2 pages)
- MCX775 V (3 pages)
- MCX775 V R3 (1 page)
- POLARIS - AMD (2 pages)
- POLARIS - INTEL (2 pages)
- HD7900 series for Radeon HD7900 (2 pages)
- Crossfire bridges X2 and X3 for Komodo 7900 (2 pages)
- SLI/Crossfire bridges for MCW60/80/82 (2 pages)
- MCB 120 Radbox (2 pages)
- MCB 120 Radbox R2 (2 pages)
- MCB 120 Radbox REV3 (2 pages)
- QPOWER (12 pages)
- QPOWER P180 (2 pages)
- MCW NBMAX (1 page)
- MCW20 A (2 pages)
- MCW20 P (2 pages)
- MCW20 R (4 pages)
- MCW30 (3 pages)
- MCW30 HARD MOUNT (4 pages)
- MCW40 (2 pages)
- MCW50 (2 pages)
- APOGEE (9 pages)
- APOGEE DRIVE (8 pages)
- APOGEE DRIVE II - Socket 775/1155/1366 (6 pages)
- APOGEE DRIVE II - Socket 2011 (5 pages)